Elecraft XG-3 - Signal Generator
Programmable signal generator
Wide-Range Synthesized RF Source
The XG3 is a programmable, 160-2 m RF signal source with four calibrated output levels. It’s ideal for receiver calibration, sensitivity tests, signal tracing, and as a VFO for home-brew projects. It’s also useful outdoors—for antenna evaluation, field strength measurements, micro-power cw beacons for T-hunts, etc.
Power for the XG3 can be provided by its internal 9-V battery or by an external power supply. Auto power-off is provided to conserve battery life.
Remote Control and Programmable Sweeps
The XG3’s serial port allows you to use a computer to set up its frequency and output level, assign frequencies to band switches, and set up sweep step size and rate. You can use the supplied PC software, or write your own XG3 applications.
The XG3’s RS232 drive circuitry is intended for short cable lengths (6’ supplied). You can also use the Elecraft KUSB or other USB-to-RS232 adapters, greatly extending the usable cable length.
Miniature RF source for shack or field use – only 2.5 x 4.4 x 0.9”
1.5-200 MHz range, with a typical resolution of 1-24 Hz. (Up to 1400 MHz via harmonics)
12 programmable bands for 160-2 m (Or use as arbitrary memories on any frequency.)
Four calibrated power output levels:
107 dBm (1 uV)
-73 dBm (50 uV, S9)
-33 dBm (S9+40)
Two programmable sweep functions
CW and RTTY Beacon Modes
Computer Controllable; Downloadable firmware upgrades
Includes RS-232 Cable. (See KUSB adapter for USB interfaces.)